Garage Door Sensor Repair

Door won't close? It's often the sensors.

If your garage door starts to close and then reverses — or refuses to close at all — the safety sensors are the most common culprit. These photo-eye sensors sit near the floor on each side of the door and must see each other clearly for the opener to run. A bump from a broom, a build-up of dust and dirt on the lens, a loose bracket, or a damaged wire can all break the beam and stop the door. Gear Garage Door, Inc. diagnoses and repairs garage door sensors — realigning brackets, cleaning lenses, and replacing sensors when they've failed — and gets your door closing again, usually the same day. Sensor trouble often goes hand in hand with the opener itself — see our garage door opener repair if the motor, remote, or wall control is also acting up.

Technician aligning a garage door safety sensor at the base of the track
Same-Day Service
Most repairs completed the day you call
Licensed & Insured
Fully licensed in Florida, fully insured
5-Star Rated
Trusted by Central Florida homeowners since 2003

What's Included

  • Safety sensor alignment and realignment
  • Dirty or blocked sensor lens cleaning
  • Sensor replacement when the unit has failed
  • Sensor bracket repair and remounting
  • Wiring checks between sensors and opener
  • Full door close/reverse testing after every fix
  • Works with LiftMaster, Genie, Craftsman, and Chamberlain openers
  • Same-day service available
Pricing
Pricing depends on the equipment and work required. Contact us for an estimate — (386) 215-1457.

How It Works

  1. 1
    Describe the behavior
    Call (386) 215-1457 and tell us what the door is doing — reversing mid-close, refusing to close, or blinking sensor lights. We can often narrow down the cause over the phone.
  2. 2
    Sensor inspection
    We check both sensors for alignment, cleanliness, indicator lights, and wiring, and confirm whether the problem is the sensors or another part of the opener system.
  3. 3
    Repair or replace
    We realign brackets, clean lenses, secure wiring, or replace failed sensors with compatible units — whatever the door actually needs.
  4. 4
    Test and verify
    We run the door through full open/close cycles and verify the safety reversal works before we leave.

Common Questions

Why won't my garage door close?

The most common cause is the safety sensors. If the two photo-eye sensors near the floor can't see each other — because one is misaligned, dirty, or blocked — the opener refuses to close the door. Sunlight glare, a bumped bracket, or a spider web can be enough. It can also be an opener or track problem, which is why we inspect the whole system.

My sensor lights are blinking — what does that mean?

Blinking sensor lights usually mean the beam is broken or the sensors are out of alignment. One sensor sends the beam and the other receives it; when they're not lined up, the indicator light flickers or goes out and the door won't close. We realign the sensors and restore the beam.

Can I just clean the sensors myself?

Sometimes a gentle wipe of the lens helps if dust is the issue — but if the sensors are misaligned, loose, or the door still won't close, a professional realignment or replacement is the reliable fix. We'll also check the wiring so the problem doesn't come back.

Do you replace garage door sensors or only repair them?

Both. We align and repair sensors whenever possible, and replace them with compatible units when a sensor has failed. Every fix is tested with a full close/reverse cycle before we leave.

Nearby Areas We Serve

The same service in nearby communities. Call (386) 215-1457 to book in any of these areas.

Ready to Get Started?

Call now for same-day service or request a free estimate online.